Design
DISKDRIVE™ mixers are ultra-slim, rim-driven, and brushless, designed for efficient liquid circulation. The pressure-proof, oil-free design has no seals, allowing for quick propeller swaps in under 10 seconds without special tools.
ADVANCING YOUR VEHICLE TO THE FUTURE
DISKDRIVE
Operation
DISKDRIVE™ mixers are user-friendly and compatible with various electronic speed controllers (ESCs). Their symmetrical design delivers equal thrust in both directions, enabling rapid directional changes.
Ultimate Endurance
Thanks to its unique hydro-lubricated construction, DISKDRIVE™ mixers are built for exceptional durability. In endurance tests, the DISKDRIVE™ 50 mixer ran continuously for over 7,000 hours and completed 1.2 million directional reversals within 1,000 hours, showing minimal wear.
FEATURES
All You Need
and Even More
Direct-drive
Hubless propeller
Low-profile design
Ultra-compact
Oil-free
Pressure-proof
PRODUCTS
Power and Control for
Your Mixing and Circulation Needs
FAQ
The propeller can be easily replaced without tools within a few seconds. By pushing against the blades very close to where they are attached to the ring, the two magnet rings can be pushed apart. The propeller can then be replaced. Just pay attention to the direction of the propeller - a clockwise propeller must be replaced with a clockwise propeller and vice versa.
Detailed instructions with pictures for a propeller change can also be found in the manuals, which you can find in the Technical Documents section of the webpage.
DISKDRIVE™ mixers are designed exclusively for liquid environments (water or other non-viscous liquids) as they rely on a liquid film forming as lubrication. We do not support the use of our thrusters in air.
Ferromagnetic particles are often found in sand but also in workshop environments. They can accumulate on the magnet rings of the mixer and end up encrusted in the stator. To remove them, you can use a soft brush to dislodge the loose particles gently or use compressed air to push them away.
In a specific setup, by pairing a CW propeller with a CCW propeller, the opposing torques cancel each other out, ensuring stable and controlled operation.
We strongly advise against operating the mixer at a voltage higher than the ones we recommend. Doing so can lead to excessive heat generation, damage the motor windings and lead to potential failure of the mixer. If you require higher voltage configurations, please contact us to discuss potential solutions or alternative models designed for your voltage requirements.
Yes, the mixer is designed to operate in saltwater environments. However, if ferromagnetic particles accumulate on the magnet rings, some corrosion may form on the stator if the mixer remains idle for an extended period. This is easy to address—simply rinse the mixer thoroughly with fresh water after use to wash away any corrosion or debris.
.png)